XPR-9 Series Two-Post Lifts 49 P/N 5900371 — Rev. D2 — May 2023
⚠ WARNING Do not run the Power Unit without Hydraulic Fluid; you will damage it.
Important electrical information:
• Improper electrical installation can damage the Power Unit motor; this damage is not covered by
the warranty.
• Use a separate circuit breaker for each Power Unit.
• Protect each circuit with a time-delay fuse or circuit breaker appropriate for the Power Unit in use.
– 220 VAC, single phase circuit.
– 208-230 VAC three phase circuit.
– 380 or 440 VAC three phase circuit.
• As you require an Electrician on site to connect the Power Unit to a power source, you might also
want to have them install the Power Disconnect Switch and the Thermal Disconnect Switch on the
same visit.
⚠ DANGER Risk of explosion. This equipment has internal arcing or parts that may spark
and should not be exposed to flammable vapors. The Power Unit’s Motor should
not be located in a recessed area or below floor level. Never expose the motor to
rain or other damp environments; damage to the motor caused by water is not
covered by the warranty.
To Next Page
Loading...
