V 1.00 15 5139 en
2.11 Personal protective equipment
Risk of injury!
If personnel are not wearing personal protective equipment, they run a
considerable risk of injury.
Personal protective equipment must be worn when transporting,
setting up, assembling, installing and maintaining the system!
It is strictly prohibited to perform assembly, installation or preventative maintenance work
on the unit without the following specified personal protective equipment.
The personnel tasked with carrying out installation or preventative maintenance must not
wear bracelets, watches or other conductive parts.
The personal protective equipment to be worn is summarised in the following information
signs. The individual equipment must be specified and assessed depending on the type
of risk (particularly for electrical hazards) existing for the unit.
Protective clothing
Use: always
Hard hat
Use: if there are suspended
loads
Safety goggles
Use: always
Table 2-2: Personal protective equipment – safety
2.12 Safety rules according to EN 50110 / NFPA 70E / VDE 0105
Electrically skilled person
Safety rules
1. Disconnect completely
2. Secure against re-connection
3. Verify that the installation is dead
4. Carry out earthing and short-circuiting
5. Provide protection against adjacent live parts
To Next Page
Loading...