V 1.00 32 5139 en
9.2 Interrupting the charging procedure
The operation of the charger does not require any interruptions during the charging
procedure. However, other influences may make it necessary to interrupt the charging
procedure.
However, please note:
The charging procedure is interrupted if the On/Off button is pressed on the front control
panel.
Press the On/Off button once.
All of the charge status lights are permanently on
If the end of charging has already been reached when the button is pressed, the
charge state traffic light illuminates in green.
The charging process is not continued when you press the On / Off button again.
To continue charging, disconnect the charging plug from the machine and
reconnect it.
The charge state traffic light starts blinking green again.
During normal operation the charging procedure should not be stopped
before the automatic shut-off occurs. Premature shut-offs lead to
insufficient charging. This can reduce the availability of the machine.
Interrupting the mains voltage
A new charging procedure is started automatically after the mains voltage has been
interrupted!
9.3 Charging procedure ends automatically
The charging procedure stops automatically if the charging programme is complete, i.e.
the machine has been charged. The charge condition traffic light then illuminates in green
(charging complete).
If the machine is needed, stop the charging.
Unplug the charging cable from the machine.
9.4 Malfunction and fault indicators
Faults and the condition of the charger are indicated by the charge status traffic light. The
meaning of the status colours or the flashing pattern that is displayed are described in
section 9.1, Description of the operating and display unit, page 30.
9.5 Shutting off the charger
The charger must be disconnected from the power supply if:
The charger is not constantly required,
The charging electronics are to be set to the initial state (Reset), e.g. if a
malfunction has been indicated.
To Next Page
Loading...