Bentel Security Academy 4 - Page 10

Step 5
Enter the identifier number of the telephone number----accepted keys
through .
Step 6 Press to save the data in the Calls section and step to the Event
Code section.
PHASE 2 active----a LED will go ON to confirm parameter acceptance.
Step 7 Enter the 2 digit event code for the SUPERKEY 1 event----accepted keys
through .
Step 8 Press to save the data in the Event Code section and step to the
Voice Message section.
PHASE 2 active----a LED will go ON to confirm parameter acceptance.
Step 9 Select the voice message for the SUPERKEY 1 event (refer to User Manual)----
accepted keys through .
+
Press for no message.
Step 10 Press to save the data in the Voice Message section and go back to
PHASE 1 Step 3.
LED 7 will flash----all other LEDs will be OFF.
If is pressed when PHASE 1 is active the programming session will close.
If is pressed when PHASE 2 is active the current parameter will not
be saved and the control panel will step back to PHASE 1 Step 3.
+
Press to save the parameter value.
Example 4
Parameter 1 (Keypads in configuration)----accepted keys through .
A brief description of the parameter can be found at the top of the KEY-
PADS table.
The u symbol at the end of the row means the parameter can be pro-
grammed in the Single mode only.
Parameter 131 (Call Type for telephone number 2)----accepted keys
through and .
A brief description can be found at the top of the TELEPHONE table.
The î symbol at the end of the row in the programming tables means the pa-
rameter can be programmed in both Single mode and Consecutive mode.
Parameter 290 (Clock): data entry instructions can be found at the top of
the CLOCK table.
The v symbol between the "day - month - year" and also "hour and min-
utes" sections means the parameter must be programmed in Multi-sec-
tion mode.
10 Security System Control panel