WARNING Use of Freed PIN programming lowers the security level
of the system, and is done at the Installer’s own risk. The customer
must be informed of the possible consequences.
Events (Address 426)
Address 426 is for automatic programming of the Contact ID Event Codes
(refer to the table on page 26).
426 Automatic Programming for
Contact ID
Delete Event Codes and clear all
telephone numbers
u
Telephone (Address 427)
Address 427 is for the length of time (0 through 63 minutes) that the audio chan-
nel will be active after a Central station call (accepted keys through ).
Options (Address 428)
Address 428 is for switching from NC2TAST (LEDs 1 through 8 OFF) to ICON/KP
keypads (LEDs 1 through 8 ON). Press to toggle the status of the 8 LEDs.
Options (Address 429)
Arm squawk: if this option is enabled, arming by command zone or termi-
nal K will generate a short squawk (<1 sec.).
Key ON: Option enabled; Key OFF: Option disabled.
Disable redundant Arming/Disarming: if this option is enabled, arming/dis-
arming operations will not effect the current armed/disarmed status of the partitions.
Key ON: Option enabled; Key OFF: Option disabled.
Prevent arming if not ready: if this option is enabled, arming will not be
possible until all the partitions are ready to arm.
Key ON: Option enabled; Key OFF: Option disabled.
Arming/Disarming signalling changeover (for CESA and CONTACT ID):
if this option is enabled, the meaning of the Central Station Activation/Re-
store codes for Arming/Disarming operations will be inverted.
Key ON: Option enabled; Key OFF: Option disabled.
Options (Address 430)
Lock installer code: option enabled----reset of the factory default program-
ming will not default the Installer PIN.Key ON: Option disabled; Key
OFF: Option enabled
ISTPTBLEACADEMY8 0.2 120202 V.4.2 BUK2
To Previous Page
Loading...
