Bentel Security Academy 4 - Programming Modes

Press to step back to PHASE 1.
+
Press to save the parameter values.
Programming Modes
There are three parameter programming modes: Single mode, Consecu-
tive mode, Multi-section mode. Refer to examples 1, 2 and 3.
Refer to the parameter Address tables for: a brief description; the accepted
keys and / or values of each parameter and the programming mode (see
example 4).
Single mode The u symbol means the parameter can be programmed in Single mode only.
Step 1 Enter the parameter Address then press .
Step 2 Enter the parameter value then press .
(See example 4)
Consecutive
Mode
The î symbol means the parameter can be programmed in Single mode
and Consecutive mode.
Consecutive mode (for zones, outputs and telephone numbers) requires
the Address of the first parameter only, as follows.
Step 1 Enter the Address then press .
Step 2 Enter the parameter value then press .
Step 3 Enter the value of the next parameter then press , and so forth.
(See example 2)
Multi-section
Mode
The v symbol means the parameter must be programmed in Multi-sec-
tion mode.
Multi-section mode parameters have more than one section (e.g. Clock
parameter). Therefore, it will be necessary to press after completing
each section.
Step 1 Enter the Address then press .
Step 2 Enter the value of the first section then press .
Step 3 Enter the value of the second section then press .
(See example 3)
PROGRAMMING FROM KEYPAD 7