Bentel Security Academy 4 - Page 8

Example 1
Step 1 Enter the Installer PIN
Step 2
Press .
PHASE 1 active----LED L7 will flash slowly.
Step 3 Enter a valid Address (e.g. Address 1 for Keypads in configuration----ac-
cepted keys through ) then press .
PHASE 2 active----LED L6 ON.
Step4
Setup the keypads in configuration----accepted keys through .
Step 5 Press to save and step back to PHASE 1.
Step 6 Repeat the procedure from Step 3 for the other parameters.
If is pressed when PHASE 1 is active the programming session will
close.
If is pressed when PHASE 2 is active the current parameter will not
be saved and the control panel will step back to PHASE 1 Step 3.
+
Press to save the parameter value.
Example 2
Step 1 Enter the Installer PIN.
Step 2
Press .
PHASE 1 active----LED L7 will flash slowly.
Step 3
Enter a valid Address (e.g. Address 60 for Partition assignment Zone----
accepted keys through ) then press .
PHASE 2 active----LED L6 ON.
Step 4 Assign the partitions for zone 1----accepted keys through .
Step 5 Press to save parameter 60 and step to parameter 61 (Type Zone
1).
PHASE 2 active----LED L5 ON.
Step 6
Program the Type for zone 1----accepted keys through .
8 Security System Control panel