Step 7 Press to save parameter 61 and step to parameter 62 for Balance
type Zone 1.
PHASE 2 active----LED L4 ON.
Step 8
Program the Balance Type for zone 1----accepted keys through .
Step 9 Press to save parameter 62 and go to parameter 63 for Attributes
Zone 1.
PHASE 2 active----LED L3 ON.
Step 10
Program the Attributes for zone 1 ----accepted keys through .
Step 11 Press to save parameter 63 and go to parameter 64 for Alarm cy-
cles Zone 1.
PHASE 2 active----LED L2 ON.
Step 12 Enter the number of Alarm cycles for zone 1----values 0 through 15.
Step 13 Press to save parameter 64 and step back to PHASE 1 Step 3
LED 7 will flash----all other LEDs will be OFF.
If is pressed when PHASE 1 is active programming session will
close.
If is pressed when PHASE 2 is active the current parameter will not
be saved and the control panel will step back to PHASE 1 Step 3.
+
Press to save the parameter value.
Example 3
Step 1
Enter the Installer PIN.
Step 2
Press .
PHASE 1 active----LED L7 will flash slowly.
Step 3 Enter a valid Address (e.g. event 325 SUPERKEY 1----refer to "User Manual").
Step 4 Press :
PHASE 2 active----LED L6 ON
This is a Multi-section parameter with three sections:
Calls - Event Code - Voice Message. The telephone numbers (first sec-
tion) will be called when the assigned event occurs.
PROGRAMMING FROM KEYPAD 9
To Next Page
Loading...
