EasyManuals Logo

Bentel Security KYO 4 M User Manual

Bentel Security KYO 4 M
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
BENTEL SECURITY srl reserves the right to modify the technical specifications of this product without prior notice.
IMPORTANT: The following information is for disassembled Control Panels ONLY.
Ensure that the Manual you are using corresponds to, or is higher than the one requested
on the “RELEASE ISSUESlabel (see below).
Manual Release
Firmware Release
Software Release
RELEASE ISSUES
OK32 1.01
Installation Manual
User Manual
Keypad Prog. Man.
Main Unit Manual
Kyo Unit Software
1.1
1.1
1.1
1.1
5.10
If the Manual/KYO Unit Software release does not correspond, DO NOT attempt to as-
semble or install the Control Panel.
The Manual Release Number can be found at the bottom of the last page, between the
Code and Date, as shown in the Fig. below.
ISTUCBLEUNKYO 190503 P70
1.2
Manual
Release
Number
DateCode
KYO 4 M – KYO 8 M – KYO 8W M – KYO 32 M – KYO 4 P – KYO 8 P – KYO 8W P – KYO 32 P
KYO 8G L-SW1 – KYO 8G L-SW2 – KYO 32G L-SW1 – KYO 32G L-SW2
KYO 8GWP-SW1 – KYO 8GWP-SW2 – KYO 8GWL-SW1 – KYO 8GWL-SW2
KYO 8G P-SW1 KYO 8G P-SW2 – KYO 32G P-SW1 KYO 32G P-SW2
Hereby, Bentel Security, declares the above mentioned Control Panels to be in compliance with the
essential requirements and other relevant provisions of 1999/5/EC Directive.
The complete R&TTE Declaration of Conformity for each Panel can be found at
www.bentelsecurity.com/dc.html.
These Control Panels comply with
Installation of these systems must be carried out strictly in accordance with the instructions
described in this manual, and in compliance with the local laws and bylaws in force.
The above mentioned Control panels have been designed and made
to the highest standards of quality and performance.
The manufacturer recommends that the installed system should be completely tested at least once a month.
BENTEL SECURITY Srl shall not assume the responsibility
for damage arising from improper application or use.
The above mentioned Control panels have no user-friendly components, therefore,
should be serviced by authorized personnel only.
CEI 79-2 2 ed. 1993
a
.
®®

Other manuals for Bentel Security KYO 4 M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bentel Security KYO 4 M and is the answer not in the manual?

Bentel Security KYO 4 M Specifications

General IconGeneral
BrandBentel Security
ModelKYO 4 M
CategoryControl Unit
LanguageEnglish

Related product manuals