Bentone B30A - Page 23

23Bentone
5.1.3 Replacement of pump fi lter
1. Close the oil supply to the burner.
2. Loosen the pump cover’s screws.
3. Remove the fi lter and gasket.
4. Mount new gasket and fi lter.
5. Refi t the cover.
6. Open the oil supply.
7. Start the burner, check seals and combustion.
!
Use caution when operating the burner, surfaces
may be hot.
!
When servicing oil bearing components, check for
oil leakage when the burner are put into operation.
Filter
Gasket
5.1.2 Check oil line seals
When the burner has been installed and put into operation, the tightness of
the various coupling elements should be checked (A), in case of leakage -
retighten the coupling elements.
!
When servicing/replacing components that affect combustion,
fl ue gas analysis and soot test shall be carried out on the installation.