3 Bentone
General
Table of contents
1. Safety Information __________________________________ 4
2. Technical data ______________________________________ 7
2.1 Dimensions B 30 A ______________________________ 7
2.3 Working field B 30 A ____________________________ 8
2.4 Settings for nozzle and air damper _________________ 8
2.2 Electrical specification EN 60335-2-102 ____________ 8
2.5 Setting of brake plate and air flow _________________ 9
2.6 Nozzle and pump pressure _______________________ 9
2.7 Burner installation _______________________________ 9
2.8 Nozzle table___________________________________ 10
2.9 Components __________________________________ 12
3. Installation ________________________________________ 13
3.1 General rules __________________________________ 13
4. Installation ________________________________________ 14
4.1 Handling and lifting instruktion ___________________ 14
4.2 Preparations for installatoin ______________________ 15
4.3 Distribution of oil _______________________________ 15
4.4 Electrical connection ___________________________ 15
4.5 Mounting of burner on boiler _____________________ 16
4.6 Check oil line seals _____________________________ 16
4.7 Air setting ____________________________________ 17
4.8 Brake plate adjustment _________________________ 17
4.9 Example of Basic settings _______________________ 18
5. Pump ____________________________________________ 19
5.1 SUNTEC AS __________________________________ 19
6. Service ___________________________________________ 25
6.1 Combustion device ____________________________ 25
6.2 Air dampers __________________________________ 26
6.3 Fan __________________________________________ 27
6.4 Replace oil pump ______________________________ 28
6.5 Vibrations _____________________________________ 29
7. Oil Burner Control __________________________________ 30
7.1 Wiring diagram _______________________________ 30
7.2 Function LMO14/24 ____________________________ 31
7.3 Colour codes LMO14/24 ________________________ 32
7.4 Fault codes LMO14/24 _________________________ 32
8. Replacement of electrical components _______________ 33
9. Fault Location _____________________________________ 34
9.1 Burner will not start ____________________________ 34
9.2 Burner will not start after normal use ______________ 34
9.3 Delayed ignition _______________________________ 35
9.4 Noise in pump _________________________________ 35
9.5 Pump pressure ________________________________ 36
10. Log of flue gas analysis _____________________________ 37
To Next Page
Loading...
