Need help?Do you have a question about the Bentone B40 and is the answer not in the manual?
Specifies the intended applications for the burner, such as water and steam generators.
Provides detailed physical dimensions for the B30 and B40 burner models.
Outlines the operational performance ranges (kg/h, kW) for B30 and B40 burners.
Details recommended nozzle types and operating pressures for optimal performance.
Comprehensive table listing nozzle specifications (Gph, kg/h, kW, Mcal/h) at various pressures.
Identifies and illustrates the various components of the burner assembly.
Guidelines for safely handling and lifting the burner unit.
Steps for inspecting the unit and preparing the site before installation.
Instructions for designing and setting up the oil supply system for the burner.
Procedures and precautions for connecting the burner to the electrical supply.
Detailed steps for physically installing the burner onto the boiler.
How to check for and address oil leaks in the connection lines.
Method for calculating the necessary pre-purge time based on boiler type and output.
Guidelines for setting excess air levels for optimal combustion efficiency.
Charts and values for setting the nozzle assembly and air damper for B30 and B40.
Procedures for adjusting airflow, nozzle assembly, and the air pressure switch.
Steps for removing, cleaning, and reinstalling the combustion assembly.
Procedures for servicing and adjusting the burner's air dampers.
Detailed steps for replacing the oil pump unit.
Guidance on replacing electrical components within the burner.
Checks and actions related to burner vibration levels and causes.
Key technical specifications for the Suntec AS47CK oil pump.
Identifies pump components and describes one-pipe and two-pipe system configurations.
Explains the operational function of the AS47CK pump and provides suction pipe data.
Electrical schematic showing connections for the LAL 2.25 control system.
Lists and identifies all components associated with the LAL 2.25 control system.
Details the operational modes and safety features of the LAL control system.
Identifies causes and remedies for when the burner does not initiate operation.
Troubleshooting steps for issues arising after the burner has been running.
Addresses problems with delayed ignition and burner pulsation during startup.
Diagnosing and resolving problems related to pump noise and pressure.
To Next Page
General
