Bentone B40 - Default Chapter; Table of Contents

3
Bentone B 30/B 40 J/K
Table of contents
Important to remember! _____________________________________________4
1. Thechnical data
___________________________________________________ 8
1.1 Burner are intended for Eo1 use at: ____________________ 8
1.2 Dimensions B30/B40 _______________________________________ 8
1.3 Working field B30 ___________________________________________ 9
1.4 Working field B40 ___________________________________________ 9
1.6 Setting of ignition electrodes and brake plate _____ 10
1.5 Recommended nozzle and pressure _________________ 10
1.7 Nozzle table __________________________________________________ 12
1.8 Description __________________________________________________ 14
2. Installation _________________________________________________________ 16
2.1 Handling and lifting instruktion _________________________ 16
2.2 Acceptance inspection ___________________________________ 17
2.3 Preparations for installation ______________________________ 17
2.4 Distribution of oil ____________________________________________ 17
2.5 Electrical connection ______________________________________ 18
2.6 Nozzle selection ____________________________________________ 19
2.7 Setting of brake plate and air flow _____________________ 19
2.8 Burner installation __________________________________________ 19
2.9 Burner installation __________________________________________ 20
2.10 Check oil line seals _________________________________________ 20
3. Basic settings ____________________________________________________ 21
3.1 Calculate prepurge time __________________________________ 21
3.2 Recomended exsess air__________________________________ 21
3.3 Examples of basic setting B40 _________________________ 22
3.4 Setting values for nozzle assembly B 30 ____________ 23
3.5 Setting values for air damper B 30 ____________________ 23
3.6 Setting values for nozzle assembly B 40 ____________ 23
3.7 Setting values for air damper B 40 ____________________ 23
3.8 Nozzle assembly adjustment, brake plate __________ 24
3.9 Air setting _____________________________________________________ 24
3.10 Setting the air pressure switch _________________________ 24
4. Burner servicing_________________________________________________ 25
4.1 Servicing the combustion assembly _________________ 25
4.2 Servicing air dampers _____________________________________ 26
4.3 Replacement of oil pump ________________________________ 27
4.4 Replacement of electrical components ______________ 28
4.5 Vibration _______________________________________________________ 29
5. Pump instructions _____________________________________________ 30
5.1 Suntec AS47CK ____________________________________________ 30
6. Electrical equipment __________________________________________ 33
6.1 Component list LAL 2.25... _____________________________ 34
6.2 Function LAL ________________________________________________ 35
7. Fault Location ____________________________________________________ 40
7.1 Burner will not start ________________________________________ 40
7.2 Burner will not start after normal use _________________ 40
7.3 Delayed ignition, burner starts; pulsation ___________ 40
7.4 Delayed ignition _____________________________________________ 41
7.5 Noise in pump _______________________________________________ 41
7.6 Pump pressure ______________________________________________ 41
8. Declaration of conformity __________________________________ 42