Model H79
12
2. Place the spool of thread, the suitable spool cap and the wire
thread guide on spool pin. To attach the thread guide, clamp it
onto the spool pin prior to sliding on the spool of thread. NOTE:
Bobbin thread should always be used for normal embroidery.
Bobbin thread is thread speci cally made for embroidery and
usually comes in white or black. An exception is when stand alone
lace is embroidered. Use the same thread in the bobbin as is
threaded on top when embroidering stand alone lace.
3. Bring the thread through the guides and around the bobbin
winder guide. (Follow thread path illustration on top of machine).
4. Place an empty bobbin on the bobbin spindle. Put the thread
through the small hole in the side of the bobbin from the inside.
Match the groove of the bobbin with the spring on the shaft and
press the bobbin onto the shaft. Push the bobbin winder shaft to
the right. The word “bob” will be displayed in the LED screen. This
tells you when the bobbin winder is engaged.
Operation
H79_Manual.indd 12H79_Manual.indd 12 10/6/2008 4:29:05 PM10/6/2008 4:29:05 PM
To Next Page
Loading...
