Model H79
13
5. Holding the thread end, press the START/STOP button. After the
thread has wound a few times, press the START/STOP button to
stop the machine. Trim thread from top of bobbin.
6. Press START/STOP button to nish winding bobbin. Winding will
stop automatically when the bobbin is full. Press the START/STOP
button to stop the machine.
7. Push the bobbin shaft to the left and remove the bobbin by lifting
it up from the spindle. Clip the thread. NOTE: The machine will not
embroider until the shaft is returned to the left.
8. The winder speed can be increased and decreased by pushing
either buttons.
Operation
H79_Manual.indd 13H79_Manual.indd 13 10/6/2008 4:29:05 PM10/6/2008 4:29:05 PM
To Next Page
Loading...
