Sewing preparations
12
Sewing preparations
Inserting a Bobbin
Insert the bobbin so that the thread runs clockwise.
Laying the thread into the slot
Pull the thread counter clockwise into the slot.
⦁
turn power switch on (to «I»)
⦁
place empty bobbin on spindle
⦁
place thread on spool pin
⦁
attach appropriate spool disc; diameter of thread spool determines disc size
⦁
following the direction of the arrow take thread through the rear guide and
round the pre-tension stud
⦁
wind the thread two to three times around the empty bobbin and cut off any
excess thread on the thread cutter
⦁
push engaging lever against bobbin, the winder works automatically
⦁
the motor will stop automatically when the bobbin is full
Winding a Bobbin
Bobbin winding while sewing
⦁
place thread spool on vertical spool pin then, following the direction of the
arrow, take thread through the thread guide and around the pre-tension
stud
⦁
then proceed as mentioned above
Thread cutter
⦁
pull thread over thread cutter when removing the bobbin
Pulling the thread under the spring
Pull the thread to the left under the spring until it lies in the T-shaped slit at the
end of the spring. The bobbin must turn clockwise.
To Next Page
Loading...
