Bernina 325 - Thread Cutter; Changing the Needle; Changing the Presser-Foot Sole

Sewing preparations
ng prepar
16
Sewing preparations
Removing the needle
⦁
raise needle
⦁
power switch to «0» (off)
⦁
lower the presser foot
⦁
loosen the needle clamp screw
⦁
pull the needle down to remove
Inserting the needle
⦁
flat side of needle to the back
⦁
insert the needle as far as it will go
⦁
tighten the needle clamp screw
Changing the Needle
Thread cutter
On the left of the head frame
⦁
pull both threads from front to back over the cutter
⦁
the threads release automatically as soon as the first stitch is sewn
Changing the presser-foot sole
⦁
raise the needle and the presser foot shaft
⦁
power switch to «0» (off)
⦁
press the button on the shaft to release the sole
Attaching the presser-foot sole
⦁
place the presser-foot sole under the shaft so that the peg sits under the
opening of the shaft
⦁
lower the presser-foot lifter and the foot sole will click into position
3