Bernina 325 - Needle Threader; Threading the Upper Thread

Sewing preparations
ng prepar
14
Sewing preparations
Threading the Upper Thread
Attaching the thread spool
⦁
raise the needle and presser foot
⦁
power switch to «0» (off)
⦁
place foam pad on pin base
⦁
Place the sewing thread on the thread roll holder so that the thread is
unwound clockwise
⦁
attach appropriate spool disc - diameter of spool determines disc size, there
must be no clearance between the disc and the spool
⦁
take thread through rear guide A
⦁
then into slit of upper thread tension B
⦁
pull thread down to the right of the take-up cover and around C
⦁
take thread up to the left of the cover and around D, placing it in the
take-up lever
⦁
take thread down and through guides E and F
Needle threader
1 Press lever down
⦁
raise needle
⦁
lower the presser foot
⦁
hold thread to the left and back
⦁
press lever A down and simultaneously guide the thread around hook B to
the right to the needle
2 Guide thread to front of the needle
⦁
put the thread from the front into the guide C until it catches in the wire
hook
3 Release lever and thread
⦁
release lever A and thread
⦁
put the thread under the foot and pull the thread backwards or
⦁
put the thread under the foot and pull it from front to back over the thread
cutter on left side of the head frame
B
B
A
C
A
A
C
D
E
F
1
3
2