2
Safety instructions
When using an electrical appliance, basic safety
precautions should always be followed, including
the following:
Read all instructions before using this sewing
computer.
When the sewing computer is not in use, it
should
be disconnected from the electricity
supply by removing the plug from the outlet.
DANGER!
To reduce the risk of electrical shock:
1. The sewing computer should never be left
unattended when plugged in.
2. Always unplug the sewing computer from
the electrical outlet immediately after using
and before cleaning.
3. LED radiation. Do not view directly with
optical instruments. LED class 1M
WARNING!
To reduce the risk of burns, fire, electric shock or
injury to persons:
1. Use the sewing computer only for purposes
as described in this manual. Use only at-
tachments/accessory recommended by the
manufacturer as contained in this manual.
2. Do not allow the sewing computer to be
used as a toy. Close attention is necessary
when this sewing computer is used by or
near children and infirm persons. This sew-
ing computer is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or instruc-
tion concerning use of the sewing computer
by a person responsible for their safety.
Children must be kept under supervision to
ensure that they do not play with the sewing
computer.
3. Never operate this sewing computer if:
⦁
it has a damaged cord or plug
⦁
it is not working properly
⦁
it has been dropped or damaged
⦁
it has fallen into water.
Take the sewing computer to the nearest
authorized BERNINA dealer for examination,
repair, electrical or mechanical adjustment.
4. Never operate the sewing computer with
any air vents blocked. Keep ventilation
openings of the sewing computer free from
lint, dust and/or fabric bits.
5. Keep fingers away from all moving parts.
Special care is required in the needle area
of the sewing computer.
6. Never drop or insert any objects into any
opening on the sewing computer.
7. Do not use the sewing computer outdoors.
8. Do not operate the sewing computer where
aerosol products (spray) or oxygen is being
administered.
9. Do not pull or push the fabric while stitching.
This may deflect the needle, causing it to
break.
10. Do not use bent needles.
11. Always use the BERNINA original stitch
plate. The wrong stitch plate can cause
needle breakage.
12. To disconnect, turn power switch to «0»
(off), then remove the plug from the outlet.
Do not unplug by pulling the cord, instead
grasp the plug to pull it from the outlet.
13. Turn power switch to «0» (off) when making
any adjustments in the needle area, such
as changing the needle or the presser foot,
etc.
14. Always unplug the sewing computer from
the electrical outlet when carrying out clean-
ing or maintenance work or any other user
servicing adjustments mentioned in this
manual.
15. This sewing computer is provided with
double insulation (except USA and Cana-
da). Use only genuine replacement parts.
Please note the advice on the servicing of
double-insulated products.
SAFETY INSTRUCTIONS
IMPORTANT INFORMATION
To Next Page
Loading...
