Bernina 700D - Page 16

MASTERING YOUR BERNINA
®
1/04/02 700D/800DL/16
BERNINA
®
700D/800DL
MASTERING
YOUR
BERNINA
®
SERGING A TUBULAR PROJECT
Fabric: Firm cotton, 3” x 12”
Needle: 80/12 Universal
Thread: 4 cones of serger thread
Presser Foot: Standard
• Owner’s manual pg.___
• Thread the serger for a 4-thread overlock stitch.
• With right sides together, seam the fabric into a tube along the 3” side.
• Press the seam to one side. (The upper looper thread is the right side of the seam.)
• On one 12” side of the tube, cut away a 2” x ¼” section of fabric.
• Lower the presser foot and serge around the tube, cutting off ¼”. Stop serging when the knife
enters the cutout; rotate the knife up.
• Continue serging to complete the circle, overlapping the previous stitching by 1”.
• Raise the presser foot and rotate the fabric clockwise.
• Lower the presser foot and serge off the edge of the fabric.
• Return the knife to the normal cutting position.
• Trim and mount the sample.