Bernina 700D - Turning Tubes

MASTERING YOUR BERNINA
®
1/04/02 700D/800DL/49
BERNINA
®
700D/800DL
MASTERING
YOUR
BERNINA
®
TURNING TUBES
Fabric: Tricot, 2” x 6”
Needle: 75 Stretch Ballpoint
Thread: 3 cones of serger thread
Presser Foot: Standard
• Owner’s manual pg.___
• Set the serger for a narrow 3-thread overlock stitch (right needle).
• Set the needle thread tension lever between 3-5 (normal).
• Adjust stitch length to 2mm.
• Serge a thread chain several inches longer than the fabric.
• Fold the fabric, right sides together, to 1” x 6” encasing the thread
chain against the fold.
• With the folded edge aligned with the left edge of the presser
foot, serge the tube being careful not to catch the thread chain in
the stitching.
• After stitching the tube, gently pull on the thread chain and turn
the tube right side out.
• Mount the sample.