MASTERING YOUR BERNINA
®
1/04/02 700D/800DL/27
BERNINA
®
700D/800DL
MASTERING
YOUR
BERNINA
®
REVERSIBLE QUILTING
Fabric: Cut the following from cotton fabrics, muslin, and batting:
3 pieces 2” x 4”; cut 1 piece 2” x 5 ½”
Needle: 80/12 Universal, Sharp, or Microtex
Thread: 4 cones of serger thread
Presser Foot: Standard
• Owner’s manual pg.___
• Thread the serger for a 4-thread overlock stitch.
• Set all thread tension levers between 3-5 (normal).
• Optional: Increase the presser foot pressure for thick fabrics.
• Create a quilt sandwich, layering the 4” fabrics as follows: 2 muslin (right sides together), one
layer of batting, 2 layers of printed fabric (right sides together) and a layer of batting on top.
• Raise the presser foot and position the fabrics under it with the right edges of the fabric and
batting even with the left edge of the knife.
• Serge the 6 layers together, stopping as necessary to keep the right edges of the fabrics even.
• Open the layers (1 muslin, 1 quilt top, 1 batting) to the right and left of the serged seam and press.
• To serge the third section into place, layer the remaining 4” fabrics as follows: muslin to muslin,
right sides together; print to print, right sides together; batting on top.
• Serge through all 6 layers.
• Open the last 3 layers to the right side; press.
• Add the last section to the top edge of the 3 paneled quilt. Layer the 5½” fabrics as follows:
muslin to muslin, right sides together; print to print, right sides together; batting on top.
• Serge, open the layers to the top of the square, and press.
• Trim and mount the sample on the following page.
To Next Page
Loading...
