MASTERING YOUR BERNINA
®
1/04/02 700D/800DL/53
BERNINA
®
700D/800DL
MASTERING
YOUR
BERNINA
®
Fabric: 2 pieces of flat edging lace, 6” each
Needle: 70/10 Sharp or Microtex
Thread: 3 cones of serger thread
Presser Foot: Blindstitch Foot (optional accessory)
BLINDSTITCH FOOT
Joining Lace to Lace
• Owner’s manual pg.___
• Set the serger for a narrow 3-thread overlock stitch (right needle).
• Set the looper thread tension levers between 3-5 (normal).
• Loosen the right needle tension slightly.
• Pull the rolled hem lever towards you.
• Adjust the stitch length to 1.5mm.
• Attach the Blindstitch Foot.
• Move the fabric guide just to the left of the knife line on the stitch plate.
• Stiffen the lace with spray starch or fabric stiffener.
• With right sides together, place the header of the laces under the presser foot against the guide.
• Serge the laces together.
• Gently pull the lace flat and press.
• Trim and mount the sample
To Next Page
Loading...
