Bernina 700D - THREE THREAD FLATLOCK

MASTERING YOUR BERNINA
®
1/04/02 700D/800DL/58
BERNINA
®
700D/800DL
MASTERING
YOUR
BERNINA
®
THREE THREAD FLATLOCK
Fabric: Sweatshirt fleece, 4” x 6”
Needle: 80/12 Universal
Thread: 2 cones of serger thread
1 cone of Jeans Stitch

by YLI
Presser Foot: Standard
• Owner’s manual pg.___
• Set the serger for a wide 3-thread overlock stitch (left needle) with Jeans Stitch

in the
upper looper.
• Set the thread tension levers for a 3-thread flatlock stitch as directed in the Owner’s manual.
• Adjust the stitch length to 3mm. (You can shorten the stitch length slightly to fill in the stitch as
you serge.)
• Fold the fabric in half, wrong sides together, to 2” x 6”.
• Optional: Attach the Attachment Base and the Right Seam Guide. Move the Right Seam Guide
halfway between the needle and the stitch finger.
• Place the fold under the foot. Guide the fabric halfway between the left needle and the right
edge of the stitch finger (or against the Right Seam Guide).
• Slowly serge the fabric. The looper threads will extend beyond the fabric on the right side of fold.
• Gently pull the fabric flat
• Return stitch length and thread tension levers to normal.
• Trim and mount the sample.