Bernina 700D - Page 73

MASTERING YOUR BERNINA
®
1/04/02 700D/800DL/73
BERNINA
®
700D/800DL
MASTERING
YOUR
BERNINA
®
Fabric: Medium weight, 4” x 6”
10” of plastic, pre-strung beads (4mm)
Needle: 80/12 Universal
Thread: 3 cones of serger thread
Presser Foot: Multi-Purpose Foot (optional accessory)
MULTI-PURPOSE FOOT
Attaching Pre-Strung Beads
• Owner’s manual pg.___
• Following the instructions in the Owner’s manual thread the serger for a 3-thread flatlock stitch using
the right needle.
• Set all thread tension levers as directed.
• Set stitch length to 4mm.
• Attach the Multi-Purpose Foot (no guide), following the directions in the instruction leaflet for the
Multi-Purpose Foot with Guide.
• Optional: Attach the Attachment Base and the Right Seam Guide. Move the Right Seam Guide
halfway between the needle and the stitch finger.
• Lay the pre-strung beads in the groove on the top of the foot, threading them under the back groove
(see instruction leaflet for the Multi-purpose Attachment with Guide). Turn the handwheel to encase
the first beads into the thread chain.
• Fold the fabric in half to 2” x 6” and place the fabric under the foot with the fold halfway between the
needle and the stitch finger or against the right seam guide.
• Slowly flatlock the beads to the folded fabric.
• Gently pull the fabric flat.
• Mount the sample.