Machine settings
77
7.5 Upper looper converter hooked in/hooked out
By hooking in the upper looper converter, the upper looper grabs the lower looper thread so that it covers
the entire fabric edge.
Prerequisite:
• The needles are in the top position.
• Upper looper is in position «I».
• The upper looper thread is removed.
• The lower looper thread is below the upper looper.
> To hook in the upper looper converter, swing the upper looper converter to the left at the retaining
bracket.
> Lightly press the upper looper converter back on the retaining bracket and hook the snap-in lug into the
eye of the looper, making sure that the snap-in lug is completely engaged.
> To unhook the upper looper converter, press the retaining bracket of the upper looper converter back
slightly and remove the snap-in lug out of the looper eye.
> Swing the upper looper converter completely back to the right.
To Next Page
