Bernina L 890 - Threading the Coverstitch Needle Thread Left Lc;Yellow

Threading
97
Threading the coverstitch needle thread left LC/yellow
The thread path for the left coverstitch needle is marked in yellow.
Prerequisite:
• «Preparing for threading» has been performed. (see page88)
• The presser foot is swung out. (see page43)
> Pull the thread beneath the thread guide plate to the left and through the yellow marking of the thread
deflection finger (1).
> Place the thread over the thread take-up lever cover of the coverstitch needle (2) and pull it down.
> Pull the thread around the thread take-up guide (3) upwards and pull it in the LC coverstitch thread slot
(4) towards the needle.
1
2
3
4
> Pull the thread in the 1st position from the left through the thread guide (5).
> Hook the thread into the thread guide on the needle holder, corresponding to the needle used (6).
6
5
> Thread the left coverstitch needle (LC).
> Place the thread beneath the presser foot to the back left.