Installation
Precellys
®
24
Page 12/35
4.2 Installation and Connecting the Power Supply
1. Remove the protective foam located around the holder under the cover.
WARNING :
Save this protective foam, as it must ABSOLUTELY be put back in place before shipping the
unit. If the unit is returned to the distributor or manufacturer without this protection in place,
the warranty will be void.
2. Put the toric joint in place (see § 8.2.2).
3. Check that the voltage switch located at the back of the unit matches the voltage delivered by your
electric power supply (see § 2.1).
WARNING :
If the voltage supplied to the equipment is higher than that indicated on the voltage switch (see
the rear side of the equipment), the electronics can be irreversibly damaged.
4. Ensure that both air openings and the cooling fan are clear.
WARNING :
Allow at least 15 cm of space around air inlets and outlets for proper motor ventilation.
5. Plug the PRECELLYS
®
24 into the power supply using a compatible power cord.
WARNING :
This equipment must be powered from a main supply which has a protective ground terminal.
To Next Page
Loading...
Need help?
General
