Introduction
Precellys
®
24
Page 3/35
1 Introduction
This user manual includes the required information regarding unpacking, installation, operation and
maintenance of the PRECELLYS
®
24 lyser / homogeniser.
The product’s technical specifications and the following information are subject to change
without prior notice.
1.1 Safety Information
This user manual must be read carefully before operating the PRECELLYS
®
24 lyser /
homogeniser.
If there is any doubt or concern about the safety of the equipment, please contact your local
distributor.
1.1.1 Risk of Electric Shock
Although this equipment is fully insulated and grounded, it is important for all users to be aware of
the potential hazard of using liquids close to a power supply. If any liquids are spilled, disconnect
immediately the instrument from the main power supply (remove the power cord from the AC
power input on the rear panel) and clean the equipment and the surrounding area.
Do not reconnect the equipment until it has been fully inspected.
1.1.2 Incorrect Operation
Operating this equipment in other ways than those detailed in this user manual may impair the
protection of the unit.
Do not turn the unit upside down: the PRECELLYS
®
24 must always rest on its 4 feet for fear of
damaging internal components or breaking plastic casing.
Do not operate the unit when the casing is removed; potentially lethal voltage exists within the
instrument.
Do not operate the unit with the safety ground disconnected.
Do not install unauthorised cards, spare components or accessories as this may impair the safety
of the unit and the warranty will be void.
Do not overfill the tubes as this may lead to liquid contamination and impair the safety of the
unit.
Check that the voltage indicated on the rear panel of the unit matches to the local power supply.
Check that the power cord is properly plugged-in. Colour codes are as follows:
International Code USA Code
Phase Live Brown Black
Neutral Blue White
Earth / Ground Yellow & Green Green
Bertin Technologies is not responsible for any damage or injury that may occur as a result of
operating the instrument in a different way to that stated in this document.
To Next Page
Loading...
Need help?
General
