Maintenance
Precellys
®
24
Page 32/35
8.3 Service Menu
8.3.1 Information Available
The unit firmware gives access to a “Service” menu presenting the following information, useful for
maintaining the system:
VERSION : Firmware version.
CPT : Cycle’s absolute counter device: accumulated number of cycle done by
the unit.
TIME : Running time absolute counter device: time associated to the number of
cycle run by the unit (running total only during cycle duration).
RESET : Reset: the cycle counter device and the associated running time counter
device when the unit is switched on (see § 5.2.2) can be reset after each
system maintenance.
8.3.2 Access to Service Menu
To access service menu, from the main menu, the user pushes the “Cancel” button for approximately
5 seconds.
The service menu is an unwind menu on 4 lines, the screen displays 2 lines at a time. “Up” and
“Down” buttons move selection cursor in this menu:
To reset all counter devices, the user can choose the RESET line on the menu with the cursor and
must push the “Valid” button. The system starts again and return to the main menu.
To exit service menu without resetting counter devices, the user must push the “Cancel” button
(whatever line is selected).
>CPT : 000000
TIME 000000
RESET
VERSION 3.0
To Next Page
Loading...
Need help?
General
