Beta EVO 2T Instruction Manual

53
GB
3
MAINTENANCE AND CHECKS
BRAKE PUMP OILBRAKE PUMP OIL
BRAKE PUMP OILBRAKE PUMP OIL
BRAKE PUMP OIL
FF
FF
F
ront brakeront brake
ront brakeront brake
ront brake
Check the oil level by means of oiI port-
hole
AA
AA
A. The oil level must be always vis-
ible from the porthole. In contrary case re-
store the oil level.
To restore the oil level, top up by unscrew-
ing the two screws
B, B,
B, B,
B, lifting cap
C C
C C
C and
adding oil.
WW
WW
W
arning:arning:
arning:arning:
arning:
lf you feel the lever too soft, there may be
an air bubble in the circuit. Apply to your
dealer immediately.
Note:Note:
Note:Note:
Note:
For oil changes, follow the instructions
given on the chart on pag. 66, using the
Iubricants recommended on pag. 49.
Rear brakeRear brake
Rear brakeRear brake
Rear brake
To check the oil level remove the rear
cover by unscrewing its 5 relevant screws ,
then check oil level by means of oil con-
tainer
EE
EE
E.
Oil level must never be below the minimum
level mark on container
EE
EE
E. To restore the
oil level, top up by means of oil filler cap.

Beta EVO 2T Specifications

General

Displacement	249 cc
Cooling System	Liquid cooled
Transmission	6-speed
Bore x Stroke	66.4 mm x 72 mm
Clutch	Wet multi-disc
Dry Weight	67 kg
Engine Type	2-stroke single
Front Suspension	Telescopic fork
Rear Suspension	Monoshock
Front Brake	Single disc
Rear Brake	Single disc
Fuel Capacity	2.5 liters
Frame	Aluminum