Beta EVO 2T Instruction Manual

58
MAINTENANCE AND CHECKS
GB
3
AIR FILAIR FIL
AIR FILAIR FIL
AIR FIL
TERTER
TERTER
TER
To access the filter remove the mudguard
by unscrewing the 5 screws
AA
AA
A, and then
proceed as follows:
•Remove the rear mudguard detaching the
cable of the tail lamp
•Remove filter capping and filter unscrew-
ing the 2 screws
BB
BB
B
•Wash the filter with water and soap
•Dry the filter
•Wet the filter with filter oil, removing any
excess oil so that there is no dripping
•If necessary, clean the inside of the filter
box
•Reassemble. We suggest to assemble
previously the filter capping on filter .
Note:Note:
Note:Note:
Note:
•If the filter is very dirty, wash it first with
gasoline and then with water and
shampoo.
•lf the filter is damaged, replace it
immediately.
WW
WW
W
arning:arning:
arning:arning:
arning:
After every intervention, check that
nothing has been left inside the filter box.
Clean the filter every time theClean the filter every time the
Clean the filter every time theClean the filter every time the
Clean the filter every time the
vehicle is used crossvehicle is used cross
vehicle is used crossvehicle is used cross
vehicle is used cross
--
--
-
countrycountry
countrycountry
country
..
..
.

Beta EVO 2T Specifications

General

Displacement	249 cc
Cooling System	Liquid cooled
Transmission	6-speed
Bore x Stroke	66.4 mm x 72 mm
Clutch	Wet multi-disc
Dry Weight	67 kg
Engine Type	2-stroke single
Front Suspension	Telescopic fork
Rear Suspension	Monoshock
Front Brake	Single disc
Rear Brake	Single disc
Fuel Capacity	2.5 liters
Frame	Aluminum