BGI PQ100 - Dimensions, Weights and Flow Specifications for SSI

88 pages

Save Page as PDF

To Next Page

To Previous Page

4.6 Dimensions, Weights and Flow Specifications for SSI

SSI-10 Inlet Kit (Including Rigid Tripod Assembly)

Flow Rate: 16.7 Lpm 5%

Weight: 16 Lbs. (7.3Kg)

Tripod Diameter Footprint: 51" (1.29M)

Tripod/Inlet Overall Height: 76" (1.93M)

Main Page

Preface2
Safety2
Table of Contents3
Introduction6
Principle of Operation6
Getting Started Checklist8
Included with the PQ1008
Optional Accessories Available (See Section 5)8
User Supplied Items8
How to Use the Pq100 Immediately9
What the Buttons Do9
Running the PQ100 at 16.7 Liters Per Minute9
Downloading (a Quick Start Overview)11
Specifications13
Flow Rate Precision, Accuracy and Pulsation13
Run Times for Various Applications13
Dimensions and Weights (PQ100 Main Unit Only)14
Electrical Specifications14
Hardware Requirements for PQ Software14
Dimensions, Weights and Flow Specifications for SSI15
Accessories16
Cables16
Inlets, Adapters and Filter Holders16
Batteries and Chargers17
Miscellaneous17
Operation Details18
Basic Operation18
Main Idle Display18
What to Do Next19
Setting a New Target Flow Rate19
Setting the Date and Time20
Setting the Start Date and Time21
Setting the Run Time22
Running the Pump23
6.8.1 Start Time Disabled23
6.8.2 Start Time Enabled23
6.8.3 Run Time23
6.8.4 Acoustic Phenomena at High Negative Pressure24
Verifying the Flow Rate24
Resetting the Run24
Calibration25
Entering and Using Calibration Mode25
Using a Deltacal or Trical26
Using a Rotameter27
Calibration Notes28
Installation and Use of the Pc Software29
Supported Hardware29
Installation on a Hard Disk System29
Advanced Installation29
Floppy Based Systems (no Hard Drive)29
Program Overview29
Running the Program30
Correct Utility30
Beginning a Sample Job31
Downloading31
Adding the Final Filter Weight32
Data Displays32
Managing Data Files32
Spreadsheet Support32
Ac Power Supply/Charger34
Maintenance and Service35
Replacement Component List35
Rebuilding the Pump after 5000 Hours37
Replacement of the Mass Flow Sensor38
Operational Theory38
Warranty Information39
Appendix A. Calibration Equations40
Appendix B. Troubleshooting44
Appendix C. System Batteries45
Appendix D. Military Time Chart46
Appendix E. Shutdown Messages47
Appendix F. Assembling the Pq167 Pm10 Air Sampling System49
Appendix G. Assembling the Bgitsp Air Sampling System50
Appendix H. Installing Filter Media51
Appendix I. Concentration Equation52
Appendix J. Flow Rate Stability53
Appendix K. Figures55
Appendix L. Filter Handling and Weighing64
Appendix M. External Datalogger66
Appendix N. Solar Panel Power Supply71
Appendix O. Rigid Mounting Assembly79
APPENDIX P. PQ167 HIGH ALTITUDE (Minipm )83
PQ100 Instruction Manual Revision History88

BGI PQ100 - Dimensions, Weights and Flow Specifications for SSI

Table of Contents