9.0 A.C. POWER SUPPLY/CHARGER
The PQ100 should be Recharged before use to allow for the greatest available Run Time.
Connect the Charger to the PQ100 Utility Adapter socket located on the front panel. Plug the
Charger into an appropriate power source. BE SURE TO CHECK CHARGER
SPECIFICATIONS FOR CORRECT POWER SOURCE INPUT.
Charging is activated only when AC power is actually applied to the charger. This allows the
system to be used in a long run time application where the battery is to be used for power loss
protection. While the Charger is engaged the PQ100 will display [DCin] in the lower right
corner of the display.
When the battery has reached full charge (16 hours typically), the PQ100 will then display
"Charged" in the lower right display.
THE PQ100 SHOULD ALWAYS BE CONNECTED TO THE CHARGER WHEN NOT IN
USE! THIS WILL PROVIDE MAXIMUM RUN TIME WHENEVER NEEDED AND WILL
NOT HARM THE INTERNAL BATTERY.
To Next Page
Loading...