3.0 HOW TO USE THE PQ100 IMMEDIATELY
3.1 What the Buttons do
"ON/OFF@ Turns the PQ100 On or Off.
"RESET" Press after a sampling job to clear all the counters in
preparation for the next sampling job.
"RUN/STOP" Use when the PQ100 has been reset and programmed for
another run and you now wish to start the pump.
"+" Increase
"-" Decrease
"SETUP" Traveling from screen to screen and entering the information
set on the screen.
"ENTER" Accepts new setting within the screen.
3.2 Running the PQ100 at 16.7 Liters per Minute
1. Turn the PQ-100 on (Push the "ON/OFF" button). If a message is blinking on the
display, press "ENTER" to proceed to the "MAIN IDLE DISPLAY".
2. Before you change any setups and to delete the last run push the "RESET" button.
Screen display should be:
ET0000Min TS00.00M (Date)
Q(Flow)Lpm T(Time) Bty(Capacity)%
(Date) - today=s date in military type notation; e.g., 01JAN= January 1st
(Flow) - the current flow rate selected to be regulated.
(Time) - military time; e.g., 13:08= 13 Hours 8 Minutes or 1:08 PM
(Capacity) - remaining charge in the internal battery.
To Next Page
Loading...
Need help?
General