6.6 Setting the Start Date and Time
From the "MAIN IDLE DISPLAY" press the "Setup" key three times until the message
below appears;
Set START DATE and TIME
dd mmm hh:mm eee
Where;
dd = day of the month
mmm = month
hh = hour (0-24, 24 hour system) mm = minutes (0-59)
eee = enable "On" or "Off"
Note: If AOn@ is enabled see the next section for further description of run procedure.
This sets the date and time that the sampler will begin running the pump. If all is
acceptable pressing the "Setup" key will change nothing and will step the menu to the
next selection. If a change is required, press the "Enter" key. You will notice that the day
will then remain on while the rest of the values continue flashing. The value that remains
on is the one that will change when the "+/-" keys are pressed. When the proper value has
been reached, pressing the "Enter" key will then select the next value for editing. After
all the values have been entered, pressing the "Setup" key will then write the new values
to the real time clock alarm registers and step to the next menu selection. This function
can be disabled. This means that if the Enable (eee) is set to "Off", the PQ100 will begin
to run the pump immediately when the "Run/Stop" key is pressed from the "MAIN IDLE
DISPLAY" regardless of the start time and date.
IF YOU SIMPLY WANT THE PUMP TO START RUNNING WHEN YOU PRESS
THE "RUN/STOP" KEY, THE LOWER RIGHT OF THE DISPLAY SHOULD
INDICATE OFF.
Note: When the reset key is pressed to clear the counters this setup will automatically
default to Midnight (00:00) of the next day. If some other Date and Time are required
you must reset the run first before using this menu selection (See Resetting the Counters).
RESET DOES NOT AFFECT THE ENABLE AND WILL REMAIN UNCHANGED!
To Next Page
Loading...
Need help?
General