NOTE: TO RECYCLE SAMPLE RUNS:
If after all runs have been downloaded, a lost file, mistake or a problem is discovered and
you must download a run again, the Datatrans allows the runs to be recycled as long as it
has not yet been erased as described in the Erasure Procedure below.
AFTER GREEN LIGHT GOES OFF, INDICATING ALL RUNS HAVE BEEN
DOWNLOADED, PRESSING BUTTON WILL RETRIEVE THE SERIES OF
RUNS AND REMAIN UNTIL DELETED.
THIS IS HELPFUL IF YOU ARE UNSURE OF AN UPLOADED RUN.
DATA DELETION PROCEDURE
(TO ERASE THE DATATRANS AFTER ALL RUNS HAVE BEEN TRANSFERRED)
1. Turn the power switch off.
2. Hold down the pushbutton.
3. While holding the pushbutton down, turn the power switch On.
4. The Red light will turn on, now release the button.
5. When erased, all three lights will flash 2 times in unison and 1 time in series.
6. Unit is now cleared and ready for new downloads.
Maintenance
The Datatrans requires no maintenance except for replacement of the 9-volt battery. A
spare, fresh battery should always be taken to the field.
Troubleshooting
Most of the problems that occur with the device can be traced to a bad 9-Volt battery. It
is recommended that the user purchase Duracell Alkaline Batteries which come packaged
with a cell tester. Follow the instructions given on the box or cell and determine if the
cell requires replacement or not. It is highly recommended that the user install a brand
new, fresh cell before each field use (If you forget to turn the unit off for some reason,
you will have about 18 full hours of battery use).
To Next Page
Loading...
Need help?
General