Biddle HR 25 - Smoke Detector; Temperature Sensor; Safety Instructions

HR MANUAL INTRODUCTION
Manual version 4.1 (26-07-2018)
en-11
en
1.4.2 Accessories
• Recirculation module 0
• Heating/cooling module !
• Flexible manchets @
• Pressure switch over extract air filter #
• Dirty filter warning lamp (during transport, this is stored in
the electronics module)
• b-touch operating panel with Biddle control cable
• Water-side control:
- valve and drive
-temperature sensor
•Sensor for control:
-CO
2
sensor
•Smoke detector
1.4.3 Components not supplied
The following components required for installation must be
obtained from third parties:
• threaded rods M10
• mains power cable
• control cable to building management system
• drain pipe with trap for condensate drainage
1.5 Safety instructions
1.5.1 Safety in use
Warning:
w Do not put any objects into the inlets and
outlets.
Warning:
w Do not obstruct the unit’s inlets or outlets.
Warning:
w The upper surface of the unit becomes hot
during operation.
Caution:
c In exceptional situations, water may run out of the
unit. Therefore, do not place anything under the unit
that could be damaged as a result.