HR MANUAL OPERATION VIA B-TOUCH
Manual version 4.1 (26-07-2018)
en-49
en
Installation This installation guide leads you through the most frequently
required settings.
The installation guide is started up automatically during the
first start-up of the unit or after the resetting of the factory
configuration.
Unit code For entering the unit code after replacement of the control
circuit board in a unit.
Calibrate air volume Use this function to set the fan speeds.
In 2.13.5 Calibrate air volume a description is provided of how
you can calibrate the fans.
Unit check Use this function to check the operation of the unit.
Run through the various modes in this function to check the
operation of the dampers and fans, as indicated in 2.13.4
Checking operation.
Modbus settings The settings for Modbus can be adjusted:
•Baud rate
• Communication:
-DATA bits
- Parity (N = none, E = even, O = odd)
- Stop bits
• Modbus node address (0 = use code dip switches of
the
contr
ol circuit board)
Default settings Restores the default factory settings of the setup menu. The
settings entered in the configuration menu are retained.
To Next Page
Loading...