OPERATION VIA B-TOUCH HEAT RECOVERY UNIT
en-42
en
Celsius / Fahrenheit Choose between a temperature display in degrees Celsius or
degrees Fahrenheit.
Display brightness Set the brightness of the screen to your personal preferences
or to the specific situation.
Show tips The control panel can show tips about the usage of the unit.
The display of these tips can be enabled or disabled.
3.5 Settings
The Settings menu allows you to enter settings which influ-
ence the day-to-day use of the unit.
1.
Sel
ect modes The control panel has an automatic mode and a manual mode.
With the function Select modes, you can set which of these
modes can be selected in the HOME screen.
5. Room temperature Her
e, set the temperature which is to be used by default as
the room temperature when starting up the unit.
The desired room temperature can temporarily be adjusted
on the home screen until the next start-up moment.
6. Mi
nimum air temperature For units with water heating module:
Set the minimum difference between the room temperature
(extract air) and the discharge temperature (supply air).
This difference can be increased for more comfort. A smaller
difference saves energy.
7. Mi
nimum air temperature, cooling In order to increase the level of comfort, a minimum dis-
charge temperature for cooling can be set.
8. Night temperature The night temperatur
e is used when the unit is switched off.
When the room temperature drops below this set value, the
unit will start working in order to keep the room at the night
temperature.
n This function only operates when the heating is
switched on.
To Next Page
Loading...