6 Interface BigRep STUDIO
64
a. Load a G-code from a storage device connected to the USB port (D).
b. Sort files alphabetically or by date
c. Remove a specific file from the list
d. Print a specific file
Temperature Menu
The most important parameters of a print are set in the Temperature Menu. This
menu will remain active and all values can be varied during a print.
a. Set the bed and extruder temperatures. Use one of the pre-configured
temperatures (a.1), or type in a specific temperature (a.2).
b. Change the extruder fan speed.
c. Change the print speed and flow rate for the current print (in percent).
d. Load and unload filament procedure for both extruders.
Fig. 6-3: Temperature Menu
To Next Page
Loading...
