Shenzhen Big Tree Technology CO.,LTD .
BIG TREE TECH
26 / 39
#define POWER_LOSS_RECOVERY // enable power loss recovery
#define PLR_ENABLED_DEFAULT true // true default to power loss recovery
enanbled
#define POWER_LOSS_ZRAISE 10 // raise the print head by 10mm after
power loss to prevent the nozzle from touching the printed part.
#define POWER_LOSS_STATE HIGH // set signal level， UPS 24V V1.0 returns
low level when not triggered and HIGH level when power is cut, thus this
setting needs to be HIGH.
4.3.10 RGB
#define NEOPIXEL_LED // enable Neopixel
#define NEOPIXEL_TYPE NEO_GRB // set Neopixel type
//#define NEOPIXEL_PIN 4 // disable PIN setting，use the correct signal pin
in the pin file of the motherboard
#define NEOPIXEL_PIXELS 30 // number of leds
#define NEOPIXEL_STARTUP_TEST // the light will show red green and blue
sequentially to self-test.
To Next Page
Loading...
