Name: BIGTREETECH SKR 3
Brand: BIGTREETECH
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Shenzhen Big Tree Technology CO.,LTD .

BIG TREE TECH

28 / 39

4.3.12 smart filament sensor(SFS V1.0 / V2.0)

The Smart filament sensor works by continuously sending signal to the mainboard

to communicate filament status

#define FILAMENT_MOTION_SENSOR // set encoder type

#define FILAMENT_RUNOUT_DISTANCE_MM 3 // set sensitivity，SFS V1.0 nominal

setting should be 7mm，which means if no signal of filament movement is

detected after 7mm of filament travel command, filament error will be

triggered ，SFS V2.0 nominal setting should be 3mm

The settings below also need to be set to instruct the printer to park the

nozzle after filament error is detected.

#define NOZZLE_PARK_FEATURE // park nozzle

#define NOZZLE_PARK_POINT { (X_MIN_POS + 10), (Y_MAX_POS - 10), 20 } //set

the X,Y,and Z offset coordinate of the nozzle

Questions and Answers:

Need help?

Do you have a question about the BIGTREETECH SKR 3 and is the answer not in the manual?

BIGTREETECH SKR 3 Specifications

General