Binder CB 60-UL - Selecting the Parameters

CB (E6.1) 07/2017 Page 86/145
13.3 Selecting the parameters
Here you can select the parameters, which shall be displayed graphically. To select the parameters, go to
Menu > Measurement chart > Settings > Parameters
Fixed value
08.03.2013 05:05:06
Submenu “Parameters” (chamber with O
2
control).
The current setting for each parameter is displayed.
Select the desired parameter
and press the operating button to change its status
On/Off.
The modified setting is displayed.
Parameters
Temperature On
CO2 On
O2 On
Close Home
Press the “Close” button twice to go back to the graphic display. If any parameter was set to “Off”, it will
not be included in the graphical display.