Binder FDL 115 - Page 41

FDL (E2.1) 05/2016 page 41/75
Press key
Display 1 shows
0000
(no function)
Display 2 shows Buzzer : Active
(setting of the alarm buzzer)
(actual setting: „Active“)
Select between “Active” and “Inactiv” using
arrow keys
Setting is shown in display 2.
Press key
Display 1 shows
0000
(no function)
Display 2 shows Language : English
(selection of controller language)
(actual setting: English)
Select be
tween languages German, English,
and French using arrow keys
Setting is shown in display 2.
Press key
Display 1 shows
e.g. 0004
(chamber operating hours)
Display 2 shows Oper.hs 0004:28
(operating hours up to now hhhh:mm)
(actually displayed: 4 hs 28 min)
Press key
Display 1 shows
1000
(actual setting: 1000 hs)
Display 2 shows Op.limit
1000:00
(maximum number of operating hours
hhhh:mm (actual setting: 1000 hs)
Set value using arrow keys
Setting is shown in both displays.
Press key
Display 1 shows
0000
(no function)
Display 2 shows Op.back : No
(reset counter of operating hours ?)
(actual setting: No)
Select between “Yes” and “No” using arrow
keys
Setting is shown in display 2.
Press key
Display 1 shows
0000
(no function)
Display 2 shows Protocol: MODBUS
(Selection of interface mode)
(actual setting: Modbus)
Select between protocols “MODBUS” and
“Printer” using arrow keys
Setting is shown in display 2.
Press key
Display 1 shows
e.g. 3
(actual setting: 3 min)
Display 2 shows Prt-Inv. 3
(print interval)
(actual setting: 3 min)
Select value between 0 and 255 minutes
using arrow keys
Setting is shown in displays 1 and 2.
Press key
Display 1 shows
0000
Display 2 shows Disp.LED: No
(continuous display illumination?)
(actual setting: No)
Select between “Yes” and “No” using arrow
keys
Setting is shown in display 2.