Binder KBF 115 (E5.2) - Page 7

KBF / KBF P (E5.2) 02/2012 page 7/103
7. GRAPHIC REPRESENTATION OF THE HISTORICAL MEASUREMENT (CHART
RECORDER FUNCTION) ..................................................................................... 39
7.1 Setting the storage rate ..................................................................................................................... 41
8. MANUAL MODE ................................................................................................... 42
8.1 Entering the set point values ............................................................................................................. 42
8.2 Entering the set point values for KBF P when operating without illumination ................................... 44
8.3 Performance after power failure in Manual Mode ............................................................................. 44
9. PROGRAM OPERATION ..................................................................................... 44
9.1 Menu-based program entry ............................................................................................................... 45
9.2 Entry of temperature values and fan speed ...................................................................................... 45
9.3 Entry of humidity values .................................................................................................................... 48
9.4 Selecting between “set-point ramp” and “set-point step” .................................................................. 49
9.5 Program entry as “set-point ramp” or as “set-point step” .................................................................. 50
9.6 Information on programming different temperature or humidity transitions ...................................... 52
9.7 Repetition of a section or several sections within a program ............................................................ 53
9.8 Performance after power failure in Program Mode ........................................................................... 53
9.9 Starting a previously entered program .............................................................................................. 54
9.10 Deleting a program ............................................................................................................................ 54
9.11 Template for temperature profile ....................................................................................................... 55
9.12 Template for humidity profile ............................................................................................................. 56
9.13 Program table template for temperature and fan speed rate ............................................................ 57
9.14 Program table template for humidity ................................................................................................. 58
10. TEMPERATURE SAFETY DEVICES ................................................................... 59
10.1 Over temperature protective device (class 1) ................................................................................... 59
10.2 Safety controller (temperature safety device class 3.1) .................................................................... 59
10.2.1 Safety controller set-point types .............................................................................................. 59
10.2.2 Checking and setting safety controller set-point type and safety controller set-point ............. 60
10.3 Temperature safety device class 3.3 (DIN 12880) (option) ............................................................... 61
10.3.1 Temperature safety device class 3.1 ...................................................................................... 61
10.3.2 Temperature safety device class 3.2 ...................................................................................... 62
11. NOTIFICATION AND ALARM FUNCTIONS ........................................................ 63
11.1 Notification and alarm system overview (auto diagnosis system) ..................................................... 63
11.2 Resetting the notification or alarm messages ................................................................................... 64
12. HUMIDITY SYSTEM ............................................................................................. 65
12.1 Function of the humidifying and dehumidifying system ..................................................................... 67
13. DEFROSTING AT REFRIGERATING OPERATION ............................................ 68
14. ICH COMPLIANT ILLUMINATION ACCORDING TO CPMP/ICH/279/95 (Q1B) . 69
14.1 BINDER ICH light .............................................................................................................................. 69
14.2 Adjustable light cassettes .................................................................................................................. 70
15. OPTIONS .............................................................................................................. 72
15.1 Communication software APT-COM™ 3 DataControlSystem (option) ............................................. 72
15.2 Interface RS 422 (option) .................................................................................................................. 72
15.3 Data logger kits ................................................................................................................................. 72
15.4 Analog outputs for temperature and humidity (option) ...................................................................... 73
15.5 Zero-voltage relay alarm outputs for temperature and humidity (option) .......................................... 73
15.6 Water protected internal socket (option – not for UL units) ............................................................... 74
15.7 Keyboard locking (available via BINDER INDIVIDUAL customized solutions) ................................. 75