Binder M Series - Page 23

M (E2) 04/2019 page 23/71
You can also directly enter any cursor position as a numerical input.
History representation: Toggling to any defined moment:
Press button
. The window “Cursor position”
opens to enter date and time.
Select date or time
with the arrow buttons and confirm
with ENTER.
Now you can access any moment that you would like to
recall. Enter date and time with the arrow buttons and
confirm with ENTER.
Press button
STA RT
.
History display at the selected point of time:
Top left: Date and time of the selected cursor position are
displayed.
Below: The corresponding temperature value of this mo-
ment is numerically and graphically displayed.
The cursor line marks the corresponding moment.
The available presentation depends on the pre-selected storage rate. This means the higher the storage
rate, the more precisely but shorter the data representation will be, see table below:
Storage rate
Storage duration
(hours)
(days)
5 sec
60
2.5
10 sec
120
5
1 min
720
30
5 min
3600
150
10 min
7200
300
CAUTION
Setting the storage rate clears the measured-value memory.
Danger of information loss.
 Change the storage rate ONLY if the previously registered data is no longer needed.
Cursor
position
Date
Time
Grenzwert
Offset
Date
10.01.02
Offset
Datum
30.11.13
11:34:39 15.12.13
START
Cursor
position
Date 15.12.09
Time 11:34:27
11:34:27 15.12.13
20:30:00 30.11.13
20:00:00
+22.7 °C
21:00:00
19:00:00