Biodom C15 - ALARM PRESS Troubleshooting

Biodom C15 | instructions for use, maintenance and installation | February 2019
52
Service
1. Check the turbolators and chamber beneath
them and clean them
2. Shake the handle of turbulators
3. Check the doors
4. Check the lid of the container (it has to be
shut!!!)
1. Clean connection pipe
2. Clean fan
3. Clean chimney
1. Check voltage output from electronics
2. Check white round safety pressure control
3. Replace fan
4. Replace electronic
1. If torn or damaged, replace
2. If clogged or squeezed, clean or reinstall
correctly
3. Clean the pipe that connects the white huba
and fire chamber
1. Check the value on the display (UPRS:
100~500)
2. Change the Huba (HUBA value of
underpressure)
NO
Is the Huba in order?
ALARM PRESS
UPRS YES – it has underpressure
UPRS NO – it doesen't have
underpressure
(there is a possibility of a defective
HUBA)
No underpressure in the
boiler
YES
NO
Are the silicone
tubes in order?
YES
NO
Does the fan 2
works?
NO
YES
Is outlet of flue gases
in order?
NO
YES
Underpressure is
lower than 10 Pa?