LifePro Thermal Cycler Preparations
－7－
4. Check before start
Check the following before insert the plug and power on the instrument:
1) Whether the voltage of power supply matches the voltage required by instrument. (see Chapter
II for requirements of power supply)
2) Make sure the power line pug has inserted in power socket reliably.
3) Earth the power line reliably.
5. Start
Power on, (turn power to “-”), the amplifier gives a “du-du” sound, and the fan starts to run, which
indicates the power supply is available.
“Self testing••••••” is shown on screen, and then the instrument takes about 1 to 2 minutes for self
testing. Please wait with patience. The main interface appears if no problem is found, then you can
edit, view, modify or delete the PCR amplification file.
To Next Page
Loading...
