LifePro Thermal Cycler Important Notes
— i —
Important Notes
1. Usual practice
Caution: Important information is contained in any item and should be carefully read. Failure
to observe the instruction would result in damage or abnormal function of
instrument.
Warning! The warning message requires extremely careful operation of a certain step. Failure
to observe the instruction would result in serious personal injury.
2. Safety
During operation, maintenance and repair of this instrument, the following basic safety notes shall
be observed. In case of failure to follow these measures or the warnings or notes indicated herein,
the basic protection provided by the instrument, its safety criteria of design and manufacture, and its
predicted use range would be impaired.
Hangzhou Bioer Technology Co., Ltd. shall be irresponsible for the consequence resulted from
user’s failure to observe the following requirements.
Note:
This instrument conforms to Class Ⅰ and Protection Class IP20 of GB4793.1 Standard
and it is for indoor use.
a) Instrument earth
In order to avoid electrical shock accident, the input power wire of instrument shall be reliably
earthed. This instrument uses 3-core earth plug and this plug is provided with a third (earth) leg, is
merely used for earth type power socket and is a safety unit. If the plug is impossible to insert into
the socket, the socket shall be correctly fixed by electrician; otherwise, the earth plug would lose
safe protection function.
b) Keeping apart from the live circuit
The operator shall not disassemble instrument without permission. Only qualified professionals are
allowed to replace elements or adjust the machine inside. Replacement of elements under
energizing state shall be prohibited.
c) Use of power supply
Before turning on AC power, make the power voltage consistent with the instrument-required one (a
±10% deviation is allowed). Make the rated load for power socket not below instrument’s maximum
load.
d) Power wire
Generally, this instrument uses accompanied power wire. The damaged power wire shall be
replaced by one of the same type and the same specification. It can’t be repaired. The power wire
shall neither be compressed nor be laid in gathered personnel location.
e) Insertion and withdrawal of power wire
At insertion and withdrawal of power wire, the plug shall be correctly held with hand. At insertion, the
plug shall be completely and tightly inserted into the socket and at withdrawal heavily pulling the
wire shall not be allowed.
f) Placement of instrument
This instrument shall be fixed in a low RH and low dust place apart from water source (e.g. water
pool and water pipeline) and the room shall be well ventilated, and free of corrosive gas or and
interference of strong magnetic field. The instrument shall not be placed in a wet or dusty location.
The openings on this instrument are for ventilation circulation and in order to avoid over-heat of the
To Next Page
Loading...
